AR-15 Super Safety Trigger Kit (Curved Trigger)

• 4140 steel cam (Hardened to HRC 55)

• 4140 steel lever (Hardened to HRC 55)

• Cam features Certess® Carbon DLC coating. Lever features DLC coating.

• Includes pre-cut trigger, rounded safety detent, and PLA Pro centering block.

To use the super safety in the MP5 (SP5, AP5, etc.), you will need a new lower that uses AR FCG parts and the MP5 Slip Trip. The super safety does NOT work with the stock MP5 lowers.

We do not ship to the following states: CA, CO, CT, DE, FL, HI, IL, MA, MD, MN, NJ, NY, OR, and RI.

Unleash the Beast

Built from battle-tested CNC-machined D2 tool steel (NOT Plastic), this isn’t just a trigger upgrade – it’s a damn revolution. Heat-treated for indestructible strength and finished with a badass DLC coating, this kit laughs in the face of wear and tear.

The CURVED mil-spec 4140 steel trigger comes pre-milled with precision Super Safety cuts, ready to drop in and dominate right out of the box. No gimmicks. No compromises. Just pure, unrelenting performance. Upgrade or get left behind.

Includes:  CURVED Mil-Spec Trigger, Cam, Lever and Safety Detent Pin.  Drop in and GO!

WHAT IS A SUPER SAFETY???

The Super Safety Trigger System refers to an advanced combination of an upgraded safety selector and a precision trigger, typically designed for AR-style rifles. This system is aimed at improving the overall functionality, responsiveness, and safety of the firearm.

Please note:  May not work in the following lower receivers:

• The lower receiver must be a low shelf lower receiver if it is a high shelf receiver it will require dremeling down so the bar can go back enough for the BCG to clear and fully cycle.

• Colt - May have a bar in the lower designed to prevent “certain FA” parts from going in the lower.

• This is not compatible with AR-10/LR-308, AR 12GA, AR 22LR, or any platform not using a typical FA M16 BCG.

• When first used, if you experience light primer strikes or hammer follow symptoms (typically 1-2 rounds are fired then the trigger is dead), you should replace the buffer with an H2 or H3 buffer. You may also adjust the gas block, if equipped. This resolves the issue in 99% of scenarios and we recommend using a H2 buffer to start.

• Do these fit in all AR-15s?

  • They should. There is no guarantee, but as long as it is made according to mil-spec, it should fit fine. There are some high shelf lowers that need to be machined/dremeled open to allow clearance (Colt is the most notorious, but some others may be high shelf or have blocks, please see below). There are many uppers that almost clear the lever, but usually require a Dremel to cut the upper pocket back to the locking lug. You will likely need to go from a H buffer to H2 or H3 for reliability if you get light primer strikes/hammer follow.